DYNATRAC 99-04 Ford Free-Spin Heavy-Duty Hub Conversion Kit

The Dynatrac 1999 - 2004 Ford Free-Spin Heavy-Duty Hub Conversion Kit

The 1994 to 2004 Ford 4X4 trucks have OEM sealed unitized bearing that is non-serviceable and prone to failure in as little as 25,000 miles.

A Dynatrac 99-04 Ford Free-Spin Heavy-Duty Hub Conversion Kit eliminates this weak link that could easily leave you stranded.

Installation of a Dynatrac 99-04 Ford Free-Spin Heavy-Duty Hub Conversion Kit ensures your vehicles reliability and trucks you on the road.

Now there is a way to prevent unitized bearing failure by installing a Dynatrac Ford Free Spin Heavy Duty Hub Conversion Kit.

The Dynatrac Ford Free-Spin Heavy-Duty Hub Conversion Kits are available in 2 different kits to meet the needs of your Ford vehicle.

The Dynatrac FO60-3X1104-A Free-Spin Heavy Duty Hub Conversion Kits contains Coarse Studs: 14mm X 2.0

The Dynatrac FO60-3X1104-B Free-Spin Heavy Duty Hub Conversion Kits contains Fine Studs: 14mm X 1.5

These Dynatrac Ford Free-Spin Heavy Duty Hub Conversion Kit works on the following Ford trucks:

•   1994 - 2004 Ford F250 4X4
•   1994 - 2004 Ford F350 4X4
•   1994 - 2004 Ford F450 4X4
•   1994 - 2004 Ford F550 4X4
•   1994 - 2004 Ford Excursion 4X4

From light duty to extreme use, your vehicle reliability will be insured with the installation of a Dynatrac Free-Spin Heavy Duty Hub Conversion Kit.

The benefits of Installing A Dynatrac Ford Free-Spin Heavy Duty Hub Conversion Kit are listed below:

• Fuel and Maintenance Savings
• Manual-locking hubs reduce wear and increase fuel economy by preventing parts from rotating constantly.
  
• Dynatrac Ford Free-Spin Kit report fuel economy increases of 1 to 3 miles per gallon.
• Dramatic reduction in front end vibrations once your able to unlock the front axle.
  
• Increases reliability by eliminating troublesome axle disconnect operation.
• Better Steering Control
• Ease of Maintenance
• Lower cost of ownership
  
• Dramatic increase in axle strength and reliability with 35-spline 1.50” shafts.
• Simple bolt on installation
  
• Maintains stock brakes and ABS sensors.

The Dynatrac FO60-3X1104-A and FO60-3X1104-B Free-Spin Heavy Duty Hub Conversion Kits both contains the following:

•   2 -  Dynatrac Pro 60 Spindles (customer to re-use rotor)
•   2 -  Dynatrac Pro 60 8 on 170 mm Wheel Hubs
•   16 -  Kit Specific Wheel Studs
•   2 -  Heavy-duty spindle kits
•   2 -  Pro 60 Dynatrac Heavy-duty, 35-spline, outer axle shafts
•   1 -  Set of Warn Premium manual locking hubs (35-spline)
•   1 -  User serviceable Timken inner and outer Wheel Bearings
  
•   1 -  ABS tone rings and sensor mounts
•   Races, Seals and Hardware.
•   Made In The USA!

Dynatrac 99-04 Ford Free-Spin Heavy-Duty Hub Conversion Kit